Meteor ProMover 250 - Manual (Page 2)

2
PROMOVER PROMOVER PROMOVER PROMOVER 250 250 250 250 DMX Scanner DMX Scanner DMX Scanner DMX Scanner : : : :
INTRODUCTION
Thank you for having chosen METEOR-KLS PROMOVER 250.You will see you have acquired a
powerful and versatile device. It has been designed to be very flexible and user friendly, without
compromising effectiveness or professionalism.
Unpack your
PROMOVER 250.
Before you initial start-up, please make sure that there is no damage caused by transportation.
Should there be any questions or problems, consult your dealer and do NOT use the device.
SAFETY INSTRUCTIONS: (notes written in this user manual.)
CAUTION! Be careful with your operations. With a dangerous voltage you can suffer a
dangerous electric shock when touching the wires.
This PROMOVER 250 PROMOVER 250 PROMOVER 250 PROMOVER 250 has left our premises in absolutely perfect condition. In order to maintain this
condition and to ensure a safe operation, it is absolutely necessary for the user to follow the
safety instructions and follow all the warnings.
Important:
Damages caused by the disregard of this user manual are not subject to warranty. The
dealer will not accept liability for any resulting defects or problems.
CAUTION! Keep this device away from rain and moisture!
Unplug mains lead before opening the housing.
SAFETY INSTRUCTIONS
For your own safety, please read this user manual carefully before your initial start-up.
Every person involved with the installation, operation and maintenance of this device has
to:
- be qualified
- follow the instructions of this manual
- consider this manual to be part of the total product
- keep this manual for the entire service life of the product
- pass this manual on to future owners or users of this product
- include every supplementary update with the original manual
- If the device has been exposed to drastic temperature fluctuation (e.g. after
transportation). Do NOT switch it on immediately. Allow fixture to reach normal room
temperature. By not doing so, the water condensation might damage your device and
cause severe damage to lamp and circuit boards.
- Leave the device switched off until it has reached room temperature.
- This device falls under protection-Class I.
- The power plug must only be plugged into a protection Class I outlet.
- Never let the power-cord come into contact with other cables!
- Handle the power-cord and all connections to the mains with particular caution.
- Make sure that the available voltage is not higher than stated on the rear panel.
- Make sure that the power-cord is never crimped or damaged by sharp edges.
- Check the device and the power-cord from time to time.
- Always disconnect from the mains, when the device is not in use or before cleaning it.
- Only handle the power-cord by the plug.
- Never pull out the plug by tugging the power-cord.