Minka Group F853-WH - Manual (Page 10)

REMEMBER to turn off the power. Follow the steps below to hang your
fan properly;
Step 1: Remove the clevis pin and hitch pin from downrod assembly.
(Fig. 5)
Step 2: Carefully feed fan wires, through the downrod and slide the canopy,
canopy cover and coupler up around over the downrod. (Fig. 6)
Step 3: Thread the rod into the motor, coupling and tighten the set screw,
clevis pin and hitch pin. (Fig.7)
Step 4: Secure the hanger bracket to the ceiling outlet box using screws
included with your outlet box and washers included with the fan.(Fig.8)
Step 5: Now lift motor assembly into position and place downrod ball
into hanger bracket. Rotate until the check groove has dropped into the
registration slot and seats firmly. Rod should not rotate if this is done
correctly(Fig.9)
HANGING THE FAN
4
WARNING: All of the parts, hardware and components such as the
hanger bracket and hanger ball have been provided for your safety
and the proper installation of your new ceiling fan. The use of other parts,
hardware or components not supplied by Minka Aire with the fan will
void the Minka Aire Warranty.