A&D 191 - Manual (Page 6)

Introduction
11111
Installing the P Installing the P Installing the P Installing the P Installing the Paper aper aper aper aper
This manual is split into the following main sections:
•
Introduction
• Installation
• Operation
• Maintenance
• Printer Test and Setup
• Communication
• Default Settings
Installation
Follow the precautions listed below when setting up your
printer. They are designed to help you keep your printer
working at its best.
- Plug your power supply into an appropriate grounded
outlet.
- Place your printer on a flat hard surface, like a tabletop.
- Keep your printer out of direct sunlight.
1. Remove the printer cover by pressing on the
groove patterns to pop the front edge up. Lift off
the cover.
2. Press the rocker switch to the left. The light will
go off.
3. Unroll several inches of the paper.
4. Cut a straight edge on the paper roll if it is jagged.