Australian Monitor AMD200 - Manual (Page 13)

1. BGM 1
1. Mic\Line 1
1. Mic\Line 5
2. BGM 2
2. Mic\Line 2
2. Mic\Line 6
3. BGM 3
3. Mic\Line 3
3. Mic\Line 7
4. BGM 4
4. Mic\Line 4
4. Mic\Line 8
5. BGM Off
5. BGM
5. BGM
6. BGM Mute
6. Master
6. Master
7. BGM Vol +
+ Volume
+ Volume
8. BGM Vol -
- Volume
- Volume
The ICON-CP can be used to control certain functions of the AMD100/200.
The set up the control panel all you need to do is address the panel on SW1.
Switch 1-8 represent a binary address. For example to address it to ID1 all you
need to do is have number 1 on, to address it to 3 have switch 1 and 2 on.
SW2 C and D do not do anything, A and B adjust the LED settings of the panel.
With switch A high ambient light adjustment will be turned on. With switch B on,
low brightness mode will be activated. Only one switch should be up at a time.
ID 1:
In this mode the fi rst 5 buttons act as a source select (1-4 and off)
The 6th button acts as a mute control
Buttons 7 and 8 are volume up and volume down for the BGM source
NOTE:
BGM Off deselects all the BGM input.
BGM Mute toggles and maintains the selected BGM source for easy unmuting.
ID 2:
In this mode the panel acts as 6 individual volume controls.
The fi rst 6 buttons pick the volume you want to control and the bottom two buttons are
volume up and volume down.
ID 3:
This mode is the same as two but controls different sources.
Note, this is will work on AMD200 only.
PAGE 13 AMD100/200 INSTALLATION AND OPERATION MANUAL
ICON-CP/AMD100-200