Silverline Multi-Head Garden System 25cc - Manual (Page 9)

8
GB
Accessories
Open-Ended Spanner
Hex Key
Box Spanner
Screwdriver
Unpacking Your Tool
• Carefully unpack and inspect your tool. Fully familiarise yourself with all
its features and functions
• Ensure that all parts of the tool are present and in good condition. If
any parts are missing or damaged, have such parts replaced before
attempting to use this tool
Preparing your cutting tools
Fitting the Trimmer Guard
1. Slide the Trimmer Guard (19) between the Trimmer Guard Brackets
(28) on the shaft
2. Use the four hex nuts and bolts supplied to secure the guard to the
bracket on the side of the shaft
Fitting the blade
1. Put a hex key through the locking hole located on the spindle housing
to lock the spindle
2. Use socket and screwdriver (or wrench) to undo the locking nut at
the base of the cutter assembly NOTE: this is reverse thread so turn
clockwise to unscrew
3. Remove the outer cap and blade bush
4. Insert blade, replace blade bush and outer cap, and re-fit locking nut
Fitting the trimmer spool
NOTE: The trimmer spool (21) is a left-handed screw-fit onto the spindle
1. Put a hex key through the locking hole located on the spindle housing
to lock the spindle
2. Use the box spanner and screwdriver (or wrench) to unscrew the
locking nut at the base of the cutter assembly NOTE: this is reverse
thread so turn clockwise to unscrew
3. Remove the outer cap, blade bush and blade (if fitted). Leave the cover
to the spindle housing in place
4. Lock the spindle by putting hex key through the locking hole
5. Thread the trimmer spool on to the spindle and tighten by hand – do
not over-tighten
NOTE: The spool does not need to be tightened by a tool
Assembling the Chainsaw
1. Unscrew the locking pin in the chainsaw coupling
2. Remove the End Cover (11) from one end of the Chainsaw Shaft (30)
and insert into the chainsaw coupling fully so that the drive shaft is
engaged
3. Align pin hole in shaft with locking pin, and tighten pin to secure shaft
in position
4. Remove the end cover from the opposite end of the chainsaw shaft,
fit the Chainsaw Lubrication Guard (2) onto the chainsaw shaft, then
replace the end cover
5. Thread the guard along the shaft up to the coupling with the chainsaw
and secure in position (Fig A) by tightening the Guard Retaining Bolt (3)
1 Chain Oil Reservoir
2 Chainsaw Lubrication Guard
3 Guard Retaining Bolt
4 Ignition Switch
5 Throttle
6 Safety Switch
7 Handle
8 Drive Unit Coupling
9 Locking Pin Cover
10 Locking Clamp
11 End Cover
12 Air Filter
13 Starter Handle
14 Fuel Tank
15 Choke Lever
16 Idling Adjustment Screw
17 Primer
18 Fuel Lines
19 Trimmer Guard
20 Adjustment Levers (Hedge Trimmer)
21 Trimmer Spool
22 Fuel Mixing Bottle
23 Hedge Trimmer
24 Brush Cutter Blade
25 Chain Tension Screw
26 Chainsaw
27 Shoulder Strap
28 Trimmer Guard Brackets
29 Brush Cutter/Trimmer Head
30 Chainsaw Shaft
31 Auxiliary Handle
32 Strap Anchor Point
33 Drive Unit
Product Familiarisation