SawStop CB73480 - Manual (Page 37)

SawStop 10” Industrial Cabinet Saw 35
Using
Your Saw
8. Using the Miter Gauge:
The miter gauge included with your saw allows
you to easily make miter cuts and perform cross-
cuts (cuts across the grain of the wood). When
not in use, the miter gauge can be stored in the
brackets formed on the front of the motor cover
(see Fig. 31).
The main bar of the miter gauge fits in the T-
shaped slots in the table which are located on
either side of the blade. The miter gauge can be
used in either slot; however, do not use the miter
gauge in the slot on the left of the blade when
making bevel cuts. Positioning the miter gauge
in the left slot when making bevel cuts causes
the blade to be tilted toward the miter gauge
and the operator’s hand which could result in a
serious injury.
7. Using the Riving Knife:
The riving knife should be used whenever the
blade guard cannot be used. The only operation
where neither the guard nor the riving knife can
be used is making dado cuts. To use the riving
knife, remove the blade guard and install the
riving knife as described on page 20. When
the blade guard / riving knife clamping bracket
is properly aligned, the riving knife will be
positioned below the top of the blade and inside
the kerf of the blade. As a result, the riving knife
can be used even for rabbet cuts and other non-
through cuts.
For successful operation, the riving knife must
remain flat so that the full height of the riving
knife is positioned inside the kerf of the blade. In
the event the riving knife becomes bent, replace
it or have it straightened before continuing to use
it. When not in use, the riving knife can be stored
on the guard / riving knife storage pin on the left
side of the cabinet (see Fig. 3) on page 14.
WARNING! Use the riving knife for every operation where the blade guard cannot be used.
Neither the blade guard nor the riving knife can be used when making dado cuts.
Using Your Saw
Fig. 31
Fig. 30
riving knife
miter gauge in
storage location
Cabinet Saw Manual 1st Reprint.i35 35 3/9/2010 8:32:51 AM