Muxlab 6G-SDI Extender Over UTP - Manual (Page 19)

© MuxLab Inc. 6G-SDI Extender Over UTP
Page 19
7. The behavior of the unit (Rx & Tx) should be as
follow during upgrade. The device uses the SDI
LEDs to indicate the actual status.

SDI A/B/C/D Blinking: Download phase.
Clear memory space and write new
image.

SDI A Blinking: Erasing previous
programmable logic memory

SDI B Blinking: Copying programmable
logic from secondary memory to primary
memory.

SDI C Blinking: Copying firmware from
secondary memory to primary memory.
8. After completion, firmware will start and the
SDI A/B/C/D LEDs will cycle.