Muxlab 6G-SDI Extender Over UTP - Manual (Page 27)

© MuxLab Inc. 6G-SDI Extender Over UTP
Page 27
Serial/USB Port Commands
1. HELP Command
help
Description: Display all the command list definition available
Response: List all available commands
help
–c <command>
Description: Help for a specific command
Response: List the specifics of the demanded command
2. RESET Command
reset
–f
Description: Reset the unit and restore the default factory settings
Response:
“ok”
3. SDI Command
sdi
–r <1,2>
Description: Set the ratio between the number of Input BNC versus
the number of outputs BNC (see table 4 for details). This command is
stored in NV memory and will remain valid after power cycle.
Arguments: <1,2> 1 = 1:1, 2 = 2:1 or 1:2
Response:
“ok”