ArtDio IPF-2000L - Manual (Page 19)

IPF-2002L User Manual
19
service type
The default service type is common. For other requests, please find the
service type in the drop down list.
service addr
• Use H.323 protocol
ƒ
If the Use Service option is checked, please fill up the IP address or
the domain name of the gatekeeper.
ƒ
If the Use Service option is unchecked, please fill up the IP address
or the domain name of the voice gateway.
• USE MGCP protocol: Please fill up the IP address or domain name of
the Call Agent.
• Use SIP protocol: If the Use Service option is checked, please fill up the
IP address or domain name of the SIP Proxy Server in this field.
service id Set service ID according to requirement of system.
nat traversal
When using a private IP to traverse the NAT, select one of the conditions:
• disable
„ When IPF-2002L is using a public IP, choose disable.
„ When IPF-2002L is using SIP protocol, and is using the Outbound
Proxy, choose disable
• enable
Automatically check the public IP of the NAT router. When IPF-2002L is
using the private IP, please choose enable. After choosing enable, the
nat addr will automatically activate. Without special request, please fill
up 00.0.0.0 in the nat addr field and properly configure the port on the
NAT router.
• stun
Use the STUN protocol. STUN enables a device to find out its public IP
address and the type of NAT service its sitting behind. It helps the SIP
traverse the NAT. If this option is selected, please also fill up the IP
address of the STUN server in the nat addr field.
nat addr
• When stun or enable is enabled in the nat traversal field, enter the NAT
Proxy’s IP address. Otherwise, keep this field as 0.0.0.0.
nat ttl
This defines how many seconds a NAT traversal message is will be sent to
the NAT server. The default setting is 30 seconds.
phone number
With H.323/MGCP/SIP protocol used, enter the phone number of the
IPF-2002L.
account
• When using the H.323 protocol to logon gatekeeper, please fill up the
H.323 ID or H.235 account.
• When choose the prefix in dialplan field, please fill up the number
provided by ISR, card number and “#”. For example 14589653185#
• With MGCP protocol used, please enter the Local name of the
EndpointID into this field.
• With SIP protocol used, fill up the SIP Proxy account.
pin
• When H.323 protocol is used to logon the gatekeeper, fill up the
password or H.235 authentication password.
• When SIP protocol is used to logon SIP Proxy Server, please fill up the
password into this field.
• When choose the prefix in the use dialplan drop-down menu, please fill