Attero Tech unDX2IO - Manual (Page 11)

unDX2IO
User Manual
 Attero Tech LLC 2013 Page 10 614-00016-01
3.2 – Device Configuration
Once the required software is installed, click on the unIFY Control Panel icon in the programs list under Attero Tech.
This will start the application.
Figure 7 - Device Configuration window
3.2.1 – Selecting a Network Adapter
In order to connect to a device the application needs to know what network adapter it should use to contact devices.
Clicking on the networked PC icon will show a list of all possible adapters.
*Note:
Only network adapters that are deemed as being compatible with Dante will be shown in the list.
3.2.2 – Connecting to a Device
A few seconds after selecting the adapter, the device list should start to populate with detected devices. The detected
devices are listed by their device name. Select the device to be configured from the drop down list and then click the
“Connect” button. The application will then attempt to establish a connection with the device. If successful, the status
bar will show “Connected” and the controls will become active and their values will update to show the current state of
the device.
This connected device is now treated as the active device and any changes to the controls will be set to this device and
this device alone.
3.2.3 – Device Identification
The device identification feature allows the user to see which device is physically being configured. When the Identify
feature is active, the power LED on the active device will flash. The Identify check box shows the state of the device
identify feature. If the box is checked, the feature is active on the active unit. If the check box is clear, the identify
feature is inactive. To change the state of the feature, simply click in the Identify check box to toggle its state from off
to on or on to off. The identify function will continue to operate until the function is turned off via the user interface or
the device is powered down.
*Note:
The identify function of Dante Controller does not control the identify feature on the unDX2IO. To identify a
device use the unIFY Control Panel identify function instead.