Attero Tech unDX2IO - Manual (Page 5)

unDX2IO
User Manual
 Attero Tech LLC 2013 Page 4 614-00016-01
1 - Overview
The unDX2IO Dante

Audio interface is a cost effective multi-IO wall box and is designed to fit into most dual gang US
junction boxes. Its size and I/O density make it easy to put Dante connectivity wherever it’s needed – near the audio
source or sink – thereby eliminating costly and interference prone analog wiring.
Figure 1 - unDX2IO front and back
It features two balanced mic/line XLR inputs and two balanced XLR line outputs with each input also supporting 48V
phantom power. All inputs and outputs can be used simultaneously and all audio channels are available separately.
Connection to the Dante network is provided by a single Ethernet RJ45 connector on the back of the unit. The unDX2IO
is PoE-enabled which allows the unDX2IO to be powered over its network cable from a suitable PoE source (IEEE 802.3af)
eliminating the need for a local power supply. This is particularly useful as the unDX2IO can then be mounted in
remote location where access to a mains outlet would be limited or indeed, non existent.
Audinate’s Dante Controller software is used to control the audio routing configuration of the device while the Attero
Tech unIFY Control Panel application can be used to configure the device-specific features, such as the mic/line
configuration, and phantom power.
The unDX2IO can be controlled and monitored via with 3
rd party Control software via a proxy service. See the unIFY
Proxy Server Users Manual for more details.
1.1 – What’s in the Box
The unDX2IO comes supplied with the following
o unDX2IO device
o Mounting kit
o Decora plate
 Dante is a trademark of Audinate Pty. Ltd.