Attero Tech unDX2IO - Manual (Page 13)

unDX2IO
User Manual
 Attero Tech LLC 2013 Page 12 614-00016-01
4 – ARCHITECTS & ENGINEERS SPECIFICATION
The Dante Break interface shall provide two XLR balanced mic/line level analog inputs and two XLR balanced line level
outputs on the front panel.
Each input shall have selectable gain options of 0dB, +25dB, and +40dB. The inputs shall have +48V phantom power.
Input gain and phantom power shall be selectable via software.
The internal analog to digital conversions shall be performed at 24-bit resolution with a 48kHz sampling rate.
The Dante interface shall receive power over the Ethernet cable from an IEE802.3af PoE compliant network switch or
mid-span injector. The Dante interface shall be in-wall mounting in a standard US dual gang junction box.
The Dante interface shall be compatible with Attero Tech unIFY software for flexible control and monitoring in systems
applications. The Dante interface shall be compliant with the RoHS directive. The Dante interface shall be compliant
with FCC Part 15 Class A, and CE (E60950 and EN55022 Class A) requirements.
The unit shall be the Attero Tech unDX2IO.
4.1 – Device Specifications
Dante Network:
Physical Level: Standard Ethernet
Connector: Single RJ-45
Cable Quality: CAT-5
Transmission
Speed:
100Mbps
Power Requirements IEEE802.3af PoE
Power Consumption Less than 3W
Dimensions 2.75”H x 3.60”W x 1.88”D
Operating
Temperature:
0 O C – 40 O C
Compliance
FCC Part 15 Class A
CE (EN60960 and
EN55022 Class A)
RoHS
Audio Inputs:
Input Type:
Balanced and RF filtered 3-
pin depluggable
Gain:
0dB, +25dB, +40dB,
software selectable
Input Impedance:
>1.8K ohms at any gain
setting
Maximum Input
Levels:
+8dBu @ 0dB gain
-16dBu @ +25dB gain
-31dBu @ +40dB gain
Phantom Power: +48V, software selectable
Audio Outputs:
Output Type:
Balanced line level with
automatic muting on loss
of Dante signal
Maximum output
level:
+12dBu
Audio Performance:
Noise: <-90dBu @ 0dB gain
System THD:
<0.01% at any gain, input
signal 3dB below
maximum