Attero Tech unDX2IO - Manual (Page 9)

unDX2IO
User Manual
 Attero Tech LLC 2013 Page 8 614-00016-01
3 – Device Configuration
There are two parts of the device that require software to setup. First the audio routing, and second the configurable
features of the device itself.
The audio routing should be carried out using Audinate’s Dante Controller. This can be obtained from the Audinate
website (
www.Audinate.com ). Instructions on how to use this software and about setting up routes on a Dante network
can also be found on their website.
*Note:
When using Dante controller, the unDX2IO will be shown using a default device name of unDX2IO###### where
‘######’ is the last six characters of the devices MAC address.
Configuration of the unDX2IO specific features is carried out using the Attero Tech unIFY Control Panel application.
This application is available from the Attero Tech website (
www.atterotech.com ). It should be used to examine and
modify the device specific features such as mic/line gain settings, phantom power, and output boost options.
3.1 – Software Installation
After downloading the application, run the .exe and the first screen to appear will be the license agreement and options
screen.
The software will install to a default location of c:\program Files (x86)\Attero Tech\unIFY Control Panel). Clicking the
“Options” button allows the user to change the installation location if required though it’s not necessary to change it.
To continue the install, read the license agreement and check the “I agree…” check box. Doing so enables the “Install”
button. Click the now enabled “Install” button to start the transfer of files.
On Windows Vista or later if the PC has the UAC enabled, a warning pop up will now appear saying the installer is about
to make changes to your PC. This needs to be accepted for the installation to complete successfully.