American Audio Q-2422/SX - Manual (Page 13)

©
American Audio
®
- www.AmericanAudio.com - Q-2422/SX User Instructions page 13
shut off before change the position of the Line Level Selector Switch.
37. CHANNEL 1 INPUT JACKS -
PHONO 1/AUX1 INPUT JACKS - The type of input must directly reflect the selected mode of
the CHANNEL 1 - LINE LEVEL SELECTOR SWITCH (36). Connect turntables equipped with
MM pickup cartridge to PHONO inputs (All DJ turntable use MM pick-up cartridges). CD
players or Tape Decks and other line level instruments may be connected to these jacks as long
as the CHANNEL 1 - LINE LEVEL SELECTOR SWITCH (36) is in the "AUX 1" position. The
red colored RCA jack represents the right channel input and the white represents the left
channel input.
LINE 1 RCA INPUT JACKS - Connect CD players or Tape Decks to these line level inputs.
Line level musical instruments with stereo outputs such as Rhythm Machines or Samplers
should also be connected to LINE inputs. Turntables should only be connected to "Phono"
inputs. The red colored RCA jack represents the right channel input and the white represents
the left channel input.
38. MIC 2 INPUT JACK -
This jack is used to a connect a microphone to the mixer. Connect you mic to
MIC 2 via 1/4 inch
(6.3mm) jack. The signal level will be controlled by the MIC 2 VOLUME CONTROL KNOB (18). BASS
(9), MID (9), and TREBLE (9) levels can be adjusted.
REAR PANEL - CONTROLS AND FUNCTIONS