Acnodes MPC 6171B - Manual (Page 37)

661 Brea Canyon Rd., Suite 3
Walnut, CA 91789
tel: 909.598.7388, fax: 909.598.0218
© Copyright 2011 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com.
MPC 6171
17” Medical Grade Panel PC
Core 2 Duo embedded system
Load Fail-Safe Defaults
This option allows you to load the troubleshooting default values permanently stored in
the BIOS ROM. These default settings are non-optimal and disable all high-perfor-
mance features.
Load Optimized Defaults
This option allows you to load the default values to your system configuration. These
default settings are optimal and enable all high performance features.
Set Supervisor Password
These two options set the system password. Supervisor Password sets a password
that will be used to protect the system and Setup utility. User Password sets a
password that will be used exclusively on the system. To specify a password, high-
light the type you want and press <Enter>. The Enter Password: message prompts on
the screen. Type the password, up to eight characters in length, and press <Enter>.
The system confirms your password by asking you to type it again. After setting a
password, the screen automatically returns to the main screen.
To disable a password, just press the <Enter> key when you are prompted to enter the
password. A message will confirm the password to be disabled. Once the password
is disabled, the system will boot and you can enter Setup freely.
Save & Exit Setup
This option allows you to determine whether or not to accept the modifications. If you
type "Y", you will quit the setup utility and save all changes into the CMOS memory. If
you type "N", you will return to Setup utility.
Exit Without Saving
Select this option to exit the Setup utility without saving the changes you have made
in this session. Typing "Y" will quit the Setup utility without saving the modifications.
Typing "N" will return you to Setup utility.