Acnodes MPC 6171B - Manual (Page 5)

661 Brea Canyon Rd., Suite 3
Walnut, CA 91789
tel: 909.598.7388, fax: 909.598.0218
© Copyright 2011 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com.
MPC 6171
17” Medical Grade Panel PC
Core 2 Duo embedded system
Electrical and Power Source Related
1. This Monitor display unit must operate on a power source as shown on the specification label. If
you are not sure what type of power supply used in the area, consult your dealer or local power
supplier.
2. The power cords must not be damaged. Applied pressure, added heat, and tugging may dam-
age the power cord.
3. The power cord must be routed properly when setup takes place. We advise that this aspect
measure is to prevent people from stepping on the cords or while the unit is suspended to prevent
flying objects from getting tangled with the unit.
4. Do not overload the AC outlets or extension cords.
Electrical shocks or fires may occur from overloading.
5. Do not touch the power source during a thunderstorm.
6. If your hands are wet, do not touch the plug.
7. Use your thumb and index finger, grip firmly on the power cord to disconnect from the electrical
socket. By pulling the power cord, may result in damaging it.
8. If the unit is not going to be in use for an extended period of time, remember to disconnect the
unit.
9. The Monitor display unit uses voltage between 90-264VAC. Connect the unit to a power source
with the same numerical value as shown. Please use only the power cord provided by the dealer to
ensure safety and EMC compliance.
Various Factors of Environment
1. Do not insert objects into the openings.
2. Do not have liquids seep into the internal areas of the Monitor display unit.
3. Having liquids seep in or inserting objects into the unit may result in electric shocks from taking
and/or short circuiting the internal parts.
4. Do not place the Monitor display unit in the presence of high moisture areas.
5. Do not install the Monitor display unit in a wet environment.
6. Do not place near unit near heat generating sources.
7. Do not place the unit in a location where it will come in contact with fumes or steam.