Kramer Electronics VP-774 - Manual (Page 18)

VP-774 - Connecting the VP-774 13
13
6. Connect an SDI source (for example, an SDI digital camera) to the SDI IN
BNC connector.
7. Connect the SDI LOOP BNC connector to an SDI monitor (for example, an
SDI display).
8. Connect the SDI OUT BNC connector to an SDI acceptor (for example, an
SDI display with speakers).
9. Connect the HDMI 1 OUT connector to an HDMI acceptor (for example, a
plasma display).
You can also connect the HDMI OUT 2 output (not shown in Figure 4 )
10. Connect the HDBT RJ-45 connector to a receiver (for example, the Kramer
TP-580Rxr).
11. Connect the AUDIO LINE OUT Terminal Block connector to a balanced
audio acceptor and the S/PDIF OUT RCA connector to a digital audio
acceptor (not shown in Figure 4 ).
12. If required, you can connect a PC and/or controller to the:
 RS-232 terminal block (see Section
8.3.2
)
 Ethernet connector (see Section 8.3.3 )
13. Connect the power cord (not shown in Figure 4 ).