Kramer Electronics VS-88HCB - Manual (Page 22)

Operating Your VS-88HCB
19
7 Operating Your VS-88HCB
Operate your VS-88HCB via:
The front panel buttons
RS-232/RS-485 serial commands transmitted by a touch screen system,
PC, or other serial controller
ETHERNET
The Kramer RC-IR2 Infrared Remote Control Transmitter
7.1 Displaying the Unit Characteristics
The VS-88HCB 7-segment Display 1 shows the selected audio 2 or video 3 input
switched to the marked output.
The unit’s characteristics
4 are displayed in the following circumstances:
Immediately (and automatically) after switching on the power; and
When simultaneously pressing and holding for 3 seconds the INPUT buttons:
1, 2 and 3 (see section 7.6)
7.2 Selecting and Connecting an Output and/or Input
To switch an input to an output, press the desired OUTPUT button, followed by
the desired INPUT button.
In addition, to:
Disconnect a video/audio Input from a specific output, press the desired
OUTPUT button followed by the OFF button. To disconnect all the
outputs, press the ALL button, followed by the OFF button
Connect a video/audio input to all outputs, press the ALL button followed
by the INPUT button corresponding to the input that is to be routed to all
the outputs
1 Item 6 in Table 1
2 When the Audio button illuminates, that is, when the audio breakaway mode is selected
3 When the Video button illuminates, that is, when the video breakaway mode is selected
4 Machine model and software version