Kramer Electronics VS-88HCB - Manual (Page 33)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Communication Protocol 2000
30
INSTRUCTION DEFINITION FOR SPECIFIC INSTRUCTION
# DESCRIPTION INPUT OUTPUT
NOTE
0 RESET MACHINE 0 0 1
1 SWITCH VIDEO Set equal to video input to be switched Set equal to video
output to be switched
(0=to all the outputs)
2
2 SWITCH AUDIO Set equal to audio input to be switched Set equal to audio
output to be switched
(0=to all the outputs)
2
3 STORE STATUS Set as SETUP #(1-8) - To store parameters
- to delete setup
2,7
4 RECALL STATUS Set as SETUP #(1-8) Don’t care 2,7
5 REQUEST STATUS
OF A VIDEO
OUTPUT
Set as SETUP #(1-8) Equal to output
number whose status
is read
3,7
6 REQUEST STATUS
OF AN AUDIO
OUTPUT
Set as SETUP #(1-8) Equal to output
number whose
status is read
3,7
7 VIS SETTING Don’t care - for immediate
switching
- for VIS switching
2
8 BREAKAWAY
SETTING
Don’t care - for audio-follow-
video
- for breakaway
2
9 NOT USED
10 REQUEST VIS
SETTING
Set as SETUP #(1-8) Don’t care 3,7
11 REQUEST
BREAKAWAY
SETTING
Set as SETUP #(1-8) Don’t care 3,7
12 to
14
NOT USED
15 REQUEST
WHETHER SETUP
IS DEFINED
Set as SETUP #(1-8) Don’t care 4
16 ERROR/BUSY Don’t care Don’t care 5
17 RESERVED 6
18 RESET MACHINE 0 0 1
19 STORE STATUS Set as SETUP #(1-8) 0-to store parameters
1-to delete setup
2,7,9
20 RECALL STATUS Set as SETUP #(1-8) Don’t care 2,7,10
21 to
56
NOT USED
57 SET AUTO-SAVE for auto save
0 – no save
Don’t care 8,2
58 to
60
RESERVED
61 IDENTIFY MACHINE 1or 2 – machine name
3 or 4 – version
Don’t care 11
NOTES on the above table:
NOTE 1 - When the master switcher is reset, (e.g. when it is turned on), the reset code is sent to the PC. If this code is sent to
the switchers, it will reset according to the present power-down settings.
NOTE 2 - These are bi-directional definitions. That is, if the switcher receives the code, it performs the instruction, and if the
instruction is performed (due to a keystroke on the front panel), then these codes are sent. For example:
0000 0001
1000 0101
1000 1000
0011
was sent from the PC, then the switcher (machine#3) will switch input 5 to output 8. If the user switched input#1 to output#7
via the front panel keypad, then the switcher will send:
0100 0001
1000 0001
1000 0111
1000 0011 to the PC.
When the PC sends one of the commands in this group to the switcher, then, if the instruction is valid, the switcher replies by
sending to the PC the same four bytes that it sent (except for the first byte, where the DESTINATION bit is set "high").