Kramer Electronics VS-88SDI - Manual (Page 26)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Communication Parameters
22
9 Communication Parameters
The following table lists the communication parameters for Protocol 2000
and Protocol 3000.
Table 7: Communication Parameters
RS-232
Protocol 2000
Protocol 3000 (Default)
Baud Rate: 9600 Baud Rate: 115,200
Data Bits: 8 Data Bits: 8
Stop Bits: 1 Stop Bits: 1
Parity: None Parity: None
Command Format: HEX Command Format: ASCII
Example (Output 1 to Input
1):
0x01, 0x81, 0x81, 0x81 Example (Output 1 to Input
1):
#AV 1>1<CR>
Switching Protocol
P2000 -> P3000
P3000 -> P2000
Command: 0x38, 0x80, 0x83, 0x81 Command: #P2000<CR>
Front Panel: Press and hold Output 1 and
Output 2 simultaneously
Front Panel: Press and hold Output 1 and Output 3
simultaneously
Ethernet
Default Settings
Reset Settings
IP Address: 192.168.1.39 Power cycle the unit while holding in the Factory Reset
button, located on the rear panel of the unit.
TCP Port #: 5000
UDP Port #: 50000
10 Using the P3K Wizard
P3K is a Kramer software program for accessing and changing device
parameters and upgrading the machine firmware. The P3K program can be
downloaded from the Kramer Web site at www.kramerelectronics.com .
10.1 Changing the Device Parameters
To change the device parameters do the following:
1. Connect a PC to the VS-88SDI using any one of the following connections:
• Connect a serial cable from an RS-232 9-pin D-sub rear panel
port on the PC to the VS-88SDI as explained in section 6.1 .
• Connect an RJ-45 Ethernet cable from the Ethernet port on the
PC to the Ethernet port on the VS-88SDI.