Kramer Electronics SP-14 - Manual (Page 10)

10
2.2.4. SDI Input
Format: SD-SDI
HD-SDI YCbCr 4:2:2 serial digital component video
3G-SDI 4:2:2 and 4:4:4 serial digital component video
Input impedance: 75 ohms.
SMPTE 292M, SMPTE 259M-C and SMPTE 424M compliant, accepts 484i, 576i, 720, 1080i and 1080p
single link formats at 270Mb, 1.485Gb or 2.97Gb rates. Level A and B transport is supported for 1080p
50, 59.94 and 60 Hz (2.97Gb rates).
2.2.5.
Analogue VGA Input
Via 5 BNC connectors
Signal formats:
640x480, 720x400, 800x600, 1024x600, 1024x768, 1280x720, 1280x768, 1280x1024, 1360x768,
1400x1050, 1440x900, 1680x1050, 1920x1080
Please note this input does not support video type signals.
2.2.6.
HDMI & DVI Inputs
HDMI 1.3 with or without HDCP, 30-bit video compatible.
DVI-D input with or without HDCP
Video signal formats
484i and 576i (SD) in double-rate formats (1440 pixels per line), 480p, 576p (ED), 720p, 1080i at 50,
59.94 & 60Hz, 1080p at 24, 25, 30, 50, 59.94 & 60Hz.
Graphic signal formats
640x480, 800x600, 852x480, 853x480, 1024x600, 1024x768, 1280x720, 1280x768, 1280x800,
1280x960 1280x1024, 1360x768, 1365x768, 1366x768, 1368x768, 1400x788, 1440x900, 1600x900,
1366x1024, 1400x1050, 1680x1050, 1600x1200, 1920x1080, 1920x1200
2.2.7. Audio Inputs
Embedded audio on SDI and HDMI
AES coaxial digital audio (4x)
2.2.8. Audio Output
Embedded audio on SDI and HDMI
AES coaxial digital audio (4x)
2.2.9. Display Output
Three output channels are provided, 3G-SDI via BNC, DVI-D via a DVI-I connector and Component
Video Output via three BNC, which are useable simultaneously, provided the input signal is not HDCP
encrypted.
Please note that this unit is HDCP compliant. This means that when the input signal has HDCP
encryption, the DVI-D output connector will carry a similarly HDCP encrypted signal and the 3G-SDI and
Component Video Output connector are disabled when output resolution is higher than 480i/576i. When
an HDCP encrypted signal is input, but the display device does not support HDCP, the output
image will turn black and the front panel displays
a “HDCP Authorization FAILED” message.
The DVI-D connector will support HDMI 1.3 with 30/36-bit video when connected to a suitable HDMI 1.3
receiver.
The Component Output is limited to 1080i50/60 and 1080p30/60 (and lower frequency) output modes.
YCbCr 4:2:2 and YCbCr 4:4:4 data mapping is supported.