WIKA IPT-11 - Manual (Page 15)

1 Push [OK]
2 Select the requested simulation variable with [->] and confirm with
[OK]
3 Set the requested value with [+] and [->].
4 Push [OK]
The simulation is now running, with 4 … 20 mA/HART a current is
outputted and with Profibus PA or Foundation Fieldbus a digital value.
How to interrupt the simulation:
à Push [ESC]
Information:
The simulation is terminated automatically 10 minutes after the last key
has been pushed.
Simulation
Start simulation?
With the reset function, modified values are reset. Three subfunctions
are available:
l Basic adjustment
-
Reset the values modified with the indicating and adjustment
module to the basic setting
l Factory setting
-
As basic adjustment, but also reset of special parameters to
the delivery status
l Peak values measured value and temperature
-
Reset the min./max. values of pressure and temperature to the
current values
Reset
Select reset?
For pressure transmitters more comprehensive units are available.
They are described in the operating instructions manual of the
respective sensor in the menu "Basic adjustments".
Unit of measurement
bar
Reset
Unit of measurement
Indicating and adjustment module for IPT-1* sensors 15
5 Set up
31549
-
EN
-081211