WIKA IPT-11 - Manual (Page 16)

The sensor is already set to the ordered national language. In this
menu item you can change the language. The following languages are
available, e.g. in software version 3.50:
l Deutsch
l English
l Français
l Espanõl
l Pycckuu
l Japanese
l Italiano
l Netherlands
l Japanese
l Chinese
Language
Deutsch
With this function
l Load parameter adjustment data from the sensor into the
indicating and adjustment module
l Write parameter adjustment data from the indicating and adjust-
ment module into the sensor
The data are permanently saved in an EEPROM memory in the
indicating and adjustment module and remain there even in case of
power failure. From there, they can be written in one or several
sensors or kept as backup for a probable sensor exchange.
Kind and volume of the copied data is stated in the operating
instructions manual of the respective sensor.
Information:
Before writing the data into the sensor, it is checked if the data fit the
sensor. If data do not fit, a fault signal is triggered or the function is
blocked. When writing data into the sensor, you will see from which
instrument type the data originate and which TAG-no. this sensor had.
The following items are checked:
l Software version
l WHG approval
l SIL activated
l Measuring principle
l Signal output
l Pressure measuring range
Language
Copy sensor data
16 Indicating and adjustment module for IPT-1* sensors
5 Set up
31549
-EN
-081211