Vision 100 preparation – American Aimers V100 Photometric Headlight Aimer User Manual
Page 3
✺
VISION 100 PREPARATION
Aimer Assembly
Assembly instructions are provided on a
separate sheet included with this Vision
100 Headlamp Aimer.
Questions? Call
1-877-343-7703 for
information and assistance.
Battery Pack
After the assembly of your aimer is
complete, you should
charge the battery
pack overnight
. To gain maximum
capacity the battery pack should go
through several charge / discharge cycles.
Your aimer is designed to operate
continually for over 3 hours. This will
equate to approximately 25-30 headlamp
aims. When the battery pack is close to
discharge the display will indicate a
“Battery Low” condition. At this time you
have approximately 30 minutes of
operation remaining. The unit will continue
to display the “Battery Low” condition
approximately every 3-4 minutes until the
battery is sufficiently discharged. At that
point the unit will automatically shut of f to
protect the Ni-Cad battery pack. You can,
however,
plug the wall charger to the
unit and continue to operate
. You then
should charge the unit overnight to restore
full battery power.
Aimer Test
Activate the aimer by pressing the
“On /
Off”
button. The display will scroll
“ Vision
100 Headlamp Alignment
System”
.
Insure that the display does not indicate
a battery low condition. If
“Battery Low”
is indicated, you should plug in the
battery charger and proceed or charge
overnight, then proceed.
Press the
“Align to Vehicle”
button. This
will activate the laser located on the side
of the aim head next to the mast. The
laser should turn on as it will be used for
vehicle alignment.
Press the
“Align to Lamp”
button. The
display should display
“Align: Lamp Too
Dim.”
Press the
“Aim Lamp”
button. The
display should indicate
“Low Audit: Lamp
Too Dim.”
Pressing the button again the
display should indicate
“Low Adjust:
Lamp Too Dim.”
Pressing the button again
should indicate
“High Audit: Lamp Too
Dim.”
Pressing the button again should
indicate
“High Adjust: Lamp Too Dim.”
Pressing the button again should indicate
“Fog Adjust: Lamp Too Dim.”
You
should be able to toggle through these
functions continually.
Page 3