Set floor slope – American Aimers V100 Photometric Headlight Aimer User Manual
Page 5
STEP 2:
●
Looking through the viewing window (A)
on top of the transit, turn the small
thumb screw knob (B) until the black
lines of the target (in the viewing
window) are in a straight line.
●
Now turn the level indicator dial (C), on
side of transit, until the bubble (D) is
centered.
●
The floor slope reading is indicated by
level / indicator dial (E). A plus (+) or (-)
reading indicates the slope of the floor /
vehicle.
STEP 1:
Since few shop areas have the same floor slope, the slope of
each aiming bay must be individually measured and entered.
A Model G2 Split Image Transit with target is provided to
measure floor slope. Place the transit at the front wheel
(either side) of the vehicle and place the target at the
rear wheel on the same side.
A
B
D
C
✺
SET FLOOR SLOPE
E
STEP 3:
Now loosen the floor slope adjustment
handle and move the adjustment handle
until the
level vial on top of the aimer
head is centered
. Tighten the floor slope
adjustment handle. This levels the aimer
head and establishes an arbitrary “0” on
the floor slope scale. Next, take the (+) or
(-) reading established in Step 2; again
loosen the handle and
add or subtract
the
number of increments
from the arbitrary
“0” location
at the line on the cam.
Retighten the adjustment handle. Floor
slope is now set for that bay. A decal on
the back of the aimer is provided to record
multiple bay floor slope readings.
FLOOR SLOPE
ADJUSTMENT
HANDLE
(-) READING
(+) READING
Page 5