Asante Technologies 8000 - Manual (Page 39)

Viewing General Information
Page 3-5
Table 3-1 describes each parameter in the General Information screen.
Table 3-1 General Information settings
Setting Description
System Up Time The amount of time the system has been running since last reset
or power on.
Bank 1 Image Version/
Date The version and compilation date of the runtime code that is
stored in Bank 1. (Running) indicates code is currently active.
Bank 2 Image Version/
Date The version and compilation date of the runtime code that is
stored in Bank 2.
Prom Image Ver/Date The version and compilation date of the PROM.
DRAM Size The size in megabytes (MB) of the unit’s Dynamic Random
Access Memory.
EEPROM Size The size in megabytes (MB) of the unit’s EEPROM.
Flash Size The size, in MB, of the switch’s flash memory, or non-volatile
RAM.
Console Baud Rate The current rate which data transfers to the console from the
IntraCore 8000.
System Name The name assigned to the IntraCore for network purposes.
System Location The physical location of the IntraCore.
System Contact Person responsible for configuration of the unit.
MAC Address The hardware address of the IntraCore 8000; this address can-
not be changed
IP Address The unit’s IP (Internet Protocol) address.
Subnet Mask The IP subnet mask for the IntraCore 8000.
Router The IP address of the default gateway router to which the
switch belongs.
Boot Load Mode The current method in use for loading the switch’s software.