MSI Z77 MPOWER - Manual (Page 26)

1-14
Gettng Started
Mountng Screw Holes
When nstallng the manboard, first nstall the necessary mountng stands requred for
an manboard on the mountng plate n your computer case. If there s an I/O back plate
that came wth the computer case, please replace t wth the I/O backplate that came
wth the manboard package. The I/O backplate should snap easly nto the computer
case wthout the need for any screws. Algn the mountng plate’s mountng stands wth
the screw holes on the manboard and secure the manboard wth the screws provded
wth your computer case. The locatons of the screw holes on the manboard are shown
below. For more nformaton, please refer to the manual that came wth the computer
case.
Important
Install the manboard on a flat surface free from unnecessary debrs.
To prevent damage to the manboard, any contact between the manboard crcutry
and the computer case, except for the mountng stands, s prohbted.
Please make sure there are no loose metal components on the manboard or wthn
the computer case that may cause a short crcut of the manboard.
•
•
•
The
I/O
ports
should
be
fac
ng
toward
the
rear
of
the
computer
case.
They
should
lne
up
w
th
the
holes
on
the
I/O backplate.