American Dryer Corp. AD-27 - Manual (Page 31)

27
c. Slide (mechanical) coin meter
1) Insert coin into slide meter (not provided or available from/by ADC).
2) Select “HI TEMP” on the rocker switch.
3) Push the “PUSH to START” switch.
4) The dryer will start and will continue through the drying and cooling cycles until the time vended has
expired.
NOTE: If the door is opened during a cycle, both the heat and motor will stop. However, the coin
meter will continue to count down in time. Continuation of the cycle will resume only after the
door has been closed and the “PUSH to START” button is again depressed.
2. OPL (Non Coin) Models
a. Microprocessor
1) When turning on power or when no cycle is in progress, light emitting diode (L.E.D.) display will
read “FILL.”
2) Select cycle ... Press the “E” on the keyboard (touch pad). The L.E.D. display will quickly show
“Ld30,” “LC04,” “F180.” The dryer will start and the display will read “dr30.”
NOTE: To stop the dryer at any time, either open the main door or press “CLEAR/STOP.”
Continuation of the cycle will resume only after the door has been closed and “ENTER/
START” is pressed.
3) The dryer will continue through the drying and cooling cycles, showing time counting downward.
NOTE: If the door is opened during a cycle, both the heat and motor will stop. However, the
microprocessor controller (computer) will continue to count down in time. Continuation of the
cycle will resume only after the door has been closed and “ENTER/START” is pressed.
4) Upon completion of drying and cooling cycles, the tone (buzzer) will sound for 5-seconds, and the
L.E.D. will read “donE,” at which time the dryer will shut off.
NOTE: If the Anti-Wrinkle program is active, the L.E.D. display will continue to read “donE,” and the
microprocessor controller (computer) will proceed through the Anti-Wrinkle program until the
maximum “Active Guard Time” has expired or until the door is opened, whichever comes first.
The L.E.D. display will read “FILL” and/or the “Amount To Start.” (i.e. “25”).
b. Dual Timer
1) Turn drying timer (left timer) to the right (->) to the desired time setting (i.e. 30 minutes).
2) Select “HI TEMP” on the rocker switch.
3) Push the “PUSH to START” switch.