Axis Communications 243SA - Manual (Page 12)

12 Using AXIS 243SA
The Live View page
If your AXIS 243SA has been customized to meet specific requirements, the buttons and
other items described below may or may not be displayed on the Live View page. The
following provides an overview of each available button:
The Video Format drop-down list allows you to temporarily change the
video format on the Live View page.
The Output buttons control an output directly from the Live View page. These buttons are
configured under Setup > Live View Config > Layout.
These buttons start/stop the Sequence Mode. This mode is created in Setup >
Live View Config > Sequence mode and automatically displays the view
from two or more video sources at set intervals.
The trigger buttons trigger an event directly from the Live View page. These
buttons are configured under Se tup > Live View Config > Layout. Click these
buttons to manually start and stop events.
Use the Snapshot button to capture a snapshot of the image currently
displayed in the window. Right-click on the image to save it in on your
computer.
The AMC viewer toolbar (AXIS Media Control) is available only with Microsoft Internet
Explorer and displays the following buttons:
The Play/Stop buttons start and stop the media stream.
The Snapshot button saves a snapshot of the video image currently displayed. The
Snapshot function and the target directory for saving snapshots can be configured
from the AMC Control Applet, which can be opened from the Windows Control
Panel or by right-clicking the image in Internet Explorer.
Click the View Full Screen button and the video image will fill the entire screen.
No other window is visible. Press Esc (Escape) on your keyboard to cancel full
screen view.
Pulse - click this button to activate the port for a defined period of time,
such as to switch on a light for 20 seconds.
Active/Inactive - click these buttons to manually start and stop a
connected device, such as to switch a light on/off.