Aiwa XR-MN5 - Manual (Page 20)

20
En
Programmed Edit Recording
As you program the CD tracks to record, Programmed Edit
Recording displays the remaining recording time for each side
of the tape, so you can easily select a set of desired tracks
within the length of your tape.
• Recording cannot start from a point halfway in the tape.
• Programmed Edit Recording cannot be used with MP3-CDs.
• You cannot program more than 30 tracks.
• You cannot program a track with a track number larger than
30.
1 Insert the recordable tape.
2 Press FUNCTION on the remote to select the CD
function, and load disc(s).
3 Hold down SHIFT and press CD EDIT/CHECK
twice on the remote in stop mode.
"PGM EDIT" and "PRGM C--00" is displayed.
4 Press the desired CD slot buttons (1-5) to select
a disc.
When using the remote, press DISC SELECT then press
the numbered button (1-5) within 6 seconds.
5 Press the numbered buttons on the remote to
enter the length of the recordable tape.
10 to 99 minutes can be specified.
- For a 60-minute tape press 6 and 10/0.
•f or g can also be used to specify tape length.
6 Press the numbered buttons on the remote to
select the first track to be recorded on side A.
-To select the 25th track, press >10, 2 and 5.
-To select the 11th track, press >10, 1 and 1.
7 Repeat step 6 to select the rest of the tracks for
side A.
The remaining recording time of side A is displayed. You
cannot select a track with a longer playing time.
8 Hold down SHIFT and press CD EDIT/CHECK on
the remote to switch to side B and select the
tracks for the side.
9 Repeat step 6 to select the tracks for side B.
10 Press REC START/REC PAUSE once to start
recording.
The tape is rewound to the beginning of the side facing
out from the unit, "REC MUTING" flashes on the display
and the lead segment is played through for 10 seconds,
and recording starts.
When recording on the side facing out from the unit (side
A) finishes, recording on the opposite side (side B) starts.
Side A
Tab for side A
To stop recording
Press s. Recording and CD playback stop simultaneously.
To check the program
1 Before recording, hold down SHIFT and press
CD EDIT/CHECK on the remote to select side A or B.
2 Press f or g repeatedly. The track number and
program number are displayed in succession.
To change the program of each side
Hold down SHIFT and press CD EDIT/CHECK on the remote
to select side A or B, and press s to clear the program for
the selected side. Then, select tracks again.
To clear the edit program
Press s twice.
Notes on AI / Programmed Edit Recording
MP3-CDs cannot be used for AI / Programmed Edit Recording.
To prevent accidental erasure
Remove the plastic tab of the cassette tape with a screwdriver
or other pointed tool. To record on the tape again, cover the
detection slot with adhesive tape.