Lenovo ThinkServer RD530 - Manual (Page 133)

Before you begin, print all the related instructions or ensure that you can view the PDF version on another
computer for reference.
Notes:
• The hot-swap hard disk drive backplane is sensitive to ESD. Ensure that you read and understand
“Handling static-sensitive devices” on page 64 first and carefully perform the operation.
• Depending on the model, your server might look slightly different from the illustrations in this topic.
• The illustrations in the following procedure show the backplane for 3.5-inch hard disk drives. For the
backplane for 2.5-inch hard disk drives, the replacement procedure is similar.
• In the following illustrations, system fans are removed in order to make the hot-swap hard disk drive
backplane clearly visible.
To replace the hot-swap hard disk drive backplane, do the following:
1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all
power cords from electrical outlets and disconnect all cables that are connected to the server.
2. If the server is installed in a rack cabinet, remove the server from the rack cabinet and place it on a flat,
clean, and static-protective surface. See the Rack Installation Instructions that comes with the server.
3. Remove the server cover. See “Removing the server cover” on page 65.
4. Locate the hot-swap hard disk drive backplane. See “Hot-swap hard disk drive backplane” on page 29.
5. Remove all the installed hot-swap hard disk drives and dummy trays (if any) from the hard disk drive
bays. See “Installing or replacing a hot-swap hard disk drive” on page 113.
6. Record the cable connections on the backplane and then disconnect all the cables from the backplane.
Chapter 6 . Installing, removing, or replacing hardware 121