Konica Minolta bizhub 282 - Manual (Page 407)

11 Utility mode
11-66 362/282/222
Utility mode
Ch
apt
er
11
!
Detail
When “Enhance Security” is set to “ON”, a password that does not meet
the password rules cannot be used. For details, refer to “Password rules”
on page 11-70.
When “Enhance Security” is set to “ON”, the software switch settings
cannot be changed. In addition, the parameters that are changed when
“Enhance Security” is set to “ON” do not return to their original settings,
even after “Enhance Security” is set to “OFF”.
Canceling an access lock (“Unlock” parameter)
Operations that the access lock is applied to are locked so that the password
cannot be entered after it has been incorrectly entered three consecutive
times. Restart the machine or, if the penalty is canceled, the password is no
longer authenticated.
By canceling the penalty, certain operations are set so that the access lock
does not apply to them and they can be unlocked.
The access lock applies to the following passwords. However, the adminis-
trator password cannot be set so that the access lock does not apply to it.
passwords for confidential documents, box passwords, user authentication
passwords, print management passwords, bulletin board F-code pass-
words, confidential box F-code passwords, and the administrator password
!
Detail
As a default, the access lock is disabled.
The software switch settings can be used to enable the access lock. For
details on the software switch settings, refer to “Specifying software
switch settings (machine functions)” on page 11-50.
Even if the access lock was disabled with the software switch settings, it
is enabled when “Enhance Security” is set to “ON”.
To cancel an access lock
1
Display the Admin. 2 screen, and then touch [Security Setting].
– For details on displaying the Admin. 2 screen, refer to “Displaying
the Administrator Management screen” on page 11-21.
The Security Setting screen appears.