Xerox Stampante Xerox 8830 con AccXES Controller serial number N5T-16835 - Manual (Page 10)

XES FEATURE KEY INSTRUCTIONS
701P39462 12/02 Page 10
Get a Single Replacement Key (AccXES Software Versions 8.0 or
Greater)
If you lose your feature key and need a replacement or have rebooted the
AccXES System creating a new KIK number after redeeming a coupon,
perform the following steps:
Note: The steps below assume that your IOT HW (Hardware) Address, the
Scanner HW Address, or Advanced Network HW Address has NOT changed (as
shown on the Printer Configuration Test Print or in the System Description
Applications.)
With Internet Access…
1. Log on to the WebPMT and make a print of the Printer Configuration Test
Print, “Minimal” (Figure 1) or access the PRINTER DEFAULTS > UTILITIES >
CONFIGURATION (Figure 5) and identify the:
•
Firmware version is 8.0 or greater. If not, go to the section in this
document entitled “Single Key Replacement, AccXES Software Versions
Prior to Version 8.0”.
•
Key Install Key (KIK).
2. Using your Internet browser, access
http://www.xes.com/keys/httpHome/keys.html .
3. Select a language (English, French, German, Italian, Spanish, or
Portuguese).
4. Click on “Get a single replacement key (AccXES v8.0 or later, or XEScan v1.1
or later)” and click “Continue”.
5. Enter the:
•
Coupon ID (obtained from the certificate or disk label in this kit)
•
KIK number then click “Continue”.
6. A “File Download” dialog box will appear, click Save. A “Save As” window will
open. Choose the location (Save In:) to save the file, and change the file
name if you desire. Click Save to save the file to your hard drive location or to
the diskette that came in this kit. Close the “Download Complete” window.
Note: You may want to rename the file to a meaningful name, but do not change
the file extension (.plt, .xky). Changing the file name will not affect the system’s
ability to read the file.
7. Repeat steps 12 - 16 (see pages 5-6) to complete this procedure.
Without Internet Access….
1. In the United States only, call Customer First at 1 877-XES-DNCS. If you are
outside the United States, please contact your support representative for
feature key instructions.
2. Repeat steps 12 - 17 (see pages 5-6) to complete this procedure.