Xerox Stampante Xerox 8830 con AccXES Controller serial number N5T-16835 - Manual (Page 5)

XES FEATURE KEY INSTRUCTIONS
701P39462 12/02 Page 5
Note: Refer to Table 1 to determine which address and serial
number is required.
8. Enter the:
•
Plotter (Printer) model.
•
IOT HW (Hardware) HW Address, Scanner HW Address,
or Advanced Network HW Address from Test Print (See
Figure 1.)
•
Scanner Serial Number (locate on the rear of the
Scanner), Machine ID (located on the printer connector
panel), or Controller Serial Number (located on the rear of
Controller) then click “Continue”.
9. Enter the IOT HW (Hardware) Address, Scanner Hardware
Address, or Advanced Network HW Address a second time and
click “Confirm.”
10. Fill in the requested name and addressing information and click
“Continue.”
11. After submitting the information, verify that all information on
the Summary Page is correct. Then click on the “Download
Feature Key (file)” button. A “File Download” dialog box will
appear, click “Save”. A “Save As” window will open. Choose
the location (Save In:) to save the file, and change the file
name if you desire. Click “Save” to save the file to your hard
drive location or to the diskette that came in this kit. Close the
“Download Complete” window.
Read the note on the web page regarding using the “Redeem
Another Coupon” button.
Note: You may want to rename the file to a meaningful name, but
do not change the file extension (.plt, .xky). Changing the file name
will not affect the system’s ability to read the file.
12. Upload the key file(s) to the Controller using the Web PMT.
•
Open the WebPMT on you workstation. Navigate to
PRINTER DEFAULTS > UTILITIES > Upload File. If
required, reference the WebPMT User Guide, Printer
Defaults, Upload File section for more information.
•
Browse to where you saved the Feature Key file in Step 11
and click on the Upload button to upload the file.
Note: The AccXES Client Tools, Document Submit Tool can also
be used (Reference the AccXES Client Tools User Guide). Send
the key file(s) the same as you would send a print job. The
Controller will recognize the file extension and load the key(s).