Xes feature key instructions – Xerox Stampante Xerox 8830 con AccXES Controller serial number N5T-16835 User Manual
Page 4
XES FEATURE KEY INSTRUCTIONS
701P39462 12/02
Page 4
Redeem a Coupon for a Feature Key (With Internet Access and
AccXES System Software Versions 8.0 or Greater)
For AccXES Systems firmware versions prior to 8.0, follow all
the instructions beginning on Page 7.
1. Locate the 16 character coupon ID on the label of the diskette
included in this kit. The coupon ID represents your Proof of
Purchase of the Feature for your system and MUST NOT be
misplaced.
2. Log on to the WebPMT and leave it open. Make a print of the
Printer Configuration Test Print, “Minimal” (Figure 1) or access
the PRINTER DEFAULTS, UTILITIES, Configuration screen on
the WebPMT (Figure 2) and identify the:
•
IOT HW (Hardware) Address, the Scanner HW Address
(00:00:AA :xx:xx:xx or 26:01:xx:xx:xx:xx), or Advanced
Network HW Address (00:00:aa:xx:xx:xx) where each xx
denotes a pair of characters) from Test Print or WebPMT,
Printer Defaults.
•
Key Install Key (KIK).
3. Using the Test Print, confirm that the firmware version in your
printer is 8.0 or greater. If not, go to the section in this
document entitled “Key Redemption With Internet Access and
AccXES System Software Versions Prior to Version 8.0.”
4. Using your Internet browser, access
5. Select a language (English, French, German, Italian, Spanish,
or Portuguese).
6. Click on “Redeem a Coupon for a Feature Key (AccXES v8.0 or
later, or XEScan v1.1 or later)” then click “Continue.”
7. Enter the following information then click “Continue”
•
Coupon ID (obtained from certificate or disk label in this
kit)
•
Feature
•
Key Install Key (KIK)
Figure 1. Printer Configuration Test Print
Firmware
Version
Advanced
Network HW
Address
Key Install Key
(KIK)
Scanner Hardware
Address
Figure 2 . WebPMT, Configuration Page
Advanced Network
Hardware Address
Key Install
Key (KIK)
Scanner & IOT
Hardware
Addresses