Arctic Cat MONSTER TRACTION P8814 - Manual (Page 10)

10 P8814pr-0920
Windshield/Dashboard
Assembly
Slot
Slot
PUSH
PUSH Hint: Remove the tape holding the hood to the vehicle.
• Pull the hood straps down and then out to unfasten them
from the button on each side of the vehicle.
• Lift the hood open.
• Insert the ends of the windshield/dashboard assembly into
the slots in each side of the vehicle.
• Push down on both ends of the windshield to "snap" it into
place. This may take extra force.
Hint: The windshield/dashboard assembly is designed to fit
one way. If you cannot "snap" it into place, turn it around and
try again!
9
Hint: The windshield and dashboard come factory assembled
and taped. If these parts come apart after removing the tape,
follow this assembly step.
• Fit the ends of the windshield into the groove and onto the
peg on each side of the dashboard.
7
Windshield
Dashboard
Peg
Hood
6
SIDE VIEW
Groove
Hood Strap
• Check to made sure that the windshield is properly
assembled to the dashboard.
8
The windshield is
properly assembled. The windshield is not properly
assembled. Remove the windshield and
turn it around so that it bends forward.