Arctic Cat MONSTER TRACTION P8814 - Manual (Page 11)

11 P8814pr-0920
• First, insert a screw through each side of the vehicle and into
the ends of the windshield/dashboard. Tighten the screws.
• Next, insert two screws through the inside of the vehicle and
into the windshield/dashboard. Tighten the screws.
• Using safety scissors, carefully cut the plastic tie holding the
shovel and clip together.
Note to Retailer: Do not cut the plastic tie. The plastic tie holds
the shovel in place for display purposes.
• Place the clip and shovel assembly onto the hood.
• First, slide a washer onto the remaining screws. Then, insert
the four screws with washers through the underside of the
hood and into the clip. Tighten the screws.
12
• Lift and lower the hood closed.
• Pull the hood strap down and over the button on each side of
the front end of the vehicle.
DASH VIEW
Clip
Shovel Hood
Hood
Screws Screws
Screws Screws
FRONT VIEW
SIDE VIEW
Screws Washers
13
Button Button
11
Hood Strap
• Insert four screws through the dashboard and into the front
end of the vehicle. Tighten the screws with a short shaft
Phillips screwdriver.
Screws
Dashboard Dashboard
FRONT VIEW 9 10