Arctic Cat MONSTER TRACTION P8814 - Manual (Page 9)

9 P8814pr-0920
• Insert two screws through the cargo bed and into the ends of
the sport bar. Tighten the screws.
BACK VIEW
Screws Screws
Cargo Bed
• Fit the seat into the vehicle. Make sure the front edge of the
seat is over the ridge in the vehicle.
2
• Position the sport bar so that the screw holes near each end
face the rear of the vehicle.
• Fit the ends of the sport bar into the slots in the top side of
the vehicle.
• Push down on both ends of the sport bar to “snap” into
place. This may take extra force.
Hint: The sport bar is designed to fit one way. If you cannot
“snap” it into place, turn it around and try again!
• Insert two screws into the seat area and four screws in the
seat back. Tighten the screws.
Screws
3
Sport Bar
Slots Slots
FRONT VIEW
Seat
Ridge Ridge
Screws Screws
PUSH
PUSH
4
5