Warning caution, Assembly – Arctic Cat MONSTER TRACTION P8814 User Manual

Page 8

Advertising
background image

8

P8814pr-0920

Children can be harmed by small parts,
sharp edges and sharp points in the vehicle's
unassembled state, or by electrical items.
Care should be taken in unpacking and
assembly of the vehicle. Children should not
handle parts, including the battery, or help in
assembly of the vehicle.

• In the unassembled state, this package

contains small parts. Adult assembly
is required.

• Use the charger in dry locations only.

WARNING

CAUTION

• Insert the fastener end of a short seat belt strap up through the

slot near the outer edge of the seat. Make sure the side of the
seat belt with the fastener faces the outer edge of the seat.

• Pull the short seat belt strap completely through the slot until

the last T-loop at the opposite end of the belt catches against
the slot.You will pull one T-loop through the slot.

• Repeat this procedure to assemble the other short seat

belt strap.

• Insert each fastener end of the long seat belt strap through

each slot in the center of the seat. Make sure the fasteners
face the outer edge of the seat.

• Pull each side of the long seat belt strap evenly through the

slots. Make sure to pull each T-loop through a slot.

Charger

Connector

1

Seat

ASSEMBLY

A

• Plug the charger connector into the battery

A

.

• Plug the charger into a standard wall outlet. The power

indicator lights

B

.

Notes:
- If power flow to the wall outlet is controlled by a switch, make

sure the switch is “ON”.

- Use the charger only in a wall outlet. Do not plug the charger

into a ceiling outlet.

• Before first-time use, charge the battery for

at least 18 hours.

Never charge the battery longer than 30 hours.

• Recharge the battery for at least 14 hours after each use of

your vehicle. Do not charge the battery longer than 30 hours.

• Once the battery is charged, disconnect the charger connector

from the battery. Unplug the charger from the wall outlet. The
battery is now ready to be installed in your vehicle. Please
see the Battery Installation section on page 14 for detailed
instructions on installing your battery. If your battery is already
installed in your vehicle, simply re-connect the motor harness
connector to the battery.

The power indicator on
the charger does not
indicate the charge status
of your battery. The power
indicator allows you to see
that there is power from
the wall outlet.

Short Seat Belts

Long Seat Belt

B

Advertising