Alloy Computer Products NS-24T01FS - Manual (Page 18)

12
Comprehensive LED indicators display the status of the switch
and the network (see the LED Indicators chapter below).
¾ 10/100BASE-T Twisted-Pair Ports
These ports support network speeds of either 10Mbps or
100Mbps, and can operate in half- and full- duplex transfer
modes. These ports also supports automatic MDI/MDIX
crossover detection function gives true “plug and play”
capability, just need to plug-in the network cable to the hub
directly and don’t care if the end node is NIC (Network Interface
Card) or switch and hub.
¾ Console Port
An RS-232 DCE console port is set up and managed the switch
via a connection to a console terminal or PC using a terminal
emulation program.
Rear Panel
AC Power Connector
Figure 4. Rear panel of the Switch
¾ AC Power Connector
This is a three-pronged (IEC) connector that supports the power
cord. Plug the female connector of the provided power cord into
this connector, and the male into a power outlet. Supported input
voltages range from 100~240V AC at 50~60Hz.