Alloy Computer Products NS-24T01FS - Manual (Page 21)

15
On : When the fibre module is installed and connected to an
Ethernet network, the FX Link/ACT LED lights on.
Blinking : When the FX Link/ACT LED is blinking, the fibre module
is transmitting or receiving data on an Ethernet network.
Off : No link.
¾ FDX: Full Duplex
On : When the FDX LED lights on, the fibre port is in full duplex
mode.
Off : When the green light is off, the fibre port is in half duplex
mode.
C
ONFIGURATION
This Switch is an unmanaged, but “smart” Switch because
programmable administration parameters make the Switch
operate more effectively than unmanaged (dumb) switches. This
chapter will describe how to configure the Switch.
Console Port (RS-232 DCE)
The console configuration requires connecting a terminal, such as
a Workstation or a PC running a terminal emulation program
(such as HyperTerminal, which is automatically installed with
Microsoft Windows) a to the RS-232 DCE console port of the
Switch.
The console port is set at the factory for the following
configuration:
„ Baud rate: 9,600
„ Data width: 8 bits