AEG L61270WDBI - Manual (Page 15)

10.2 Filling the detergent and
additives
MAX
Compartment for prewash phase,
soak programme or stain remover.
Compartment for washing phase.
Compartment for liquid additives
(fabric conditioner, starch).
Maximum level for quantity of liquid
additives.
Flap for powder or liquid detergent.
Always obey the instructions
that you find on the
packaging of the detergent
products.
10.3 Setting a programme
Turn the programme selector dial to the
required programme.
The programme dial determines the type
of washing cycle (e.g. water level, drum
movement, number of rinses) and the
washing temperature according to the
type of laundry.
The pilot light of button Start/Pausa
starts blinking.
The programme dial can be turned
either clockwise or anticlockwise.
Off = Reset programme/switching OFF
of the appliance
If you turn the programme
dial to another programme
when the appliance is
working, the yellow pilot
light of button Start/Pausa
blinks 3 times. The display
shows the message Err to
indicate a wrong selection.
The appliance does not
perform the new set
programme.
10.4 Starting the programme
Press button Start/Pausa to start the
programme. The corresponding red
indicator stops blinking.
The indicator Lavado is on to indicate
that the appliance starts operating.
The indicator Secado is on to indicate
the door is locked.
If you have chosen a delayed start with
button Inicio Diferido, the appliance will
begin the countdown.
If you set an incorrect option, the yellow
indicator of button Start/Pausa blinks for
3 times. The display shows the message
Err for some seconds.
10.5 Starting a programme
with the delay start
Set this option after you have set the
programme and before you press button
Start/Pausa.Before you start the
programme, if you wish to delay the
programme start, press button Inicio
Diferido repeatedly, to set the desired
delay.
The symbol appears on the display.
The wash programme can be delayed
from 30 min. - 60 min. - 90 min., 2 hours
and then by 1 hour up to a maximum of
20 hours.
The set delay time value appears on the
display for about 3 seconds, then the
duration of the programme appears
again.
You can modify or cancel the delay time
at any moment, before you press button
Start/Pausa.
ENGLISH 15