11 stand by, Daily use - drying, 1 drying setting – AEG L61270WDBI User Manual

Page 17: 2 timed drying, 3 end of the drying programme

Advertising
background image

Follow the below instructions to empty

out the water:
• Turn the programme selector dial to

Off.

• Set the DRAIN or SPIN programme.

• Reduce the spin speed, if needed.

• Press button Start/Pausa.

• When the programme has finished

the display shows a blinking . The

indicator Puerta bloqueada goes off.

The door can be opened.

Turn the programme selector dial to Off

to switch the appliance off.
Remove the laundry from the drum and

carefully check that the drum is empty. If

you do not intend to carry out another

wash, close the water tap. Leave the

door open to prevent the formation of

mildew and unpleasant smells.

10.11 Stand by

Once the programme has finished, after

few minutes the energy saving system

will be enable. The brightness of the

display is reduced. By pressing any

button the appliance comes out from the

energy saving status.

11. DAILY USE - DRYING

WARNING!

Refer to Safety chapters.

11.1 Drying setting

The recommended load size

is 3 kg for cottons and linen,

and 2 kg for synthetic items.

You can also to dry up to 4

kg of cotton items (see the

«Drying Programme » table).

WARNING!

Open the water tap. Put

the drain hose in the sink

or connect to the drain

pipe.

1. Load the laundry one item at a time.

2. Turn the programme dial to the

programme applicable for the items

to dry (cottons or synthetics).

To have a good drying

performance do not exceed

the maximum drying loads

recommended in the user

manual. Do not set a spin

speed lower than the

automatic speed of the set

programme.

11.2 Timed drying

1. Press the button Tiempo de secado

again and again to set the time value

(see the «Programmes for timed

drying» table).

• Each time you press this button

the time value increases by 5

minutes.

• As the appliance calculates also

the duration of the anti-crease

and the cooling phases, the

programme time will

automatically increase by some

minutes.

2. Press Start/Pausa button to start the

programme.

• The display shows regularly a new

time value.

• The indicator

is on.

If you set only 10 minutes of

drying, the appliance

performs only a cooling

phase.

If the laundry is not sufficient dry, set

again a short drying time.

11.3 End of the drying

programme

The appliance stops automatically.
• The acoustic signals operate (if they

are active).

• In the display comes on.

• The indicator of the Start/Pausa

button goes off.

ENGLISH

17

Advertising