AEG L61270WDBI - Manual (Page 18)

• The last minutes of the drying cycle
the appliance performs a cooling and
anti-crease phase. The door is still
locked. The display show a flashing .
When the door locked indicator
goes off, you can open the door.
1. Turn the programme knob to Off
position to deactivate the appliance.
After some minutes from the end of the
programme, the energy saving function
automatically deactivates the appliance.
2. Remove the laundry from the
appliance.
Make sure that the drum is empty.
3. Keep the door ajar, to prevent
mildew and odours.
4. Close the water tap.
12. DAILY USE - WASHING & DRYING
WARNING!
Refer to Safety chapters.
12.1 Non-Stop programme
(Automatic washing & drying)
For NON-STOP programme the
recommended load size is 3 kg for
cotton and 2 kg for synthetic.
CAUTION!
Do not use a dosing
device/ball when carrying
out a washing and drying
programme.
1. Load the laundry one item at a time.
2. Put the detergent and the additives
in the appropriate compartment.
3. Turn the programme knob to the
required programme to switch the
machine on.
4. Set the available options.
To have a good drying
performance do not exceed
the maximum drying loads
recommended in the user
manual. Do not set a spin
speed lower than the
automatic speed of the set
programme.
12.2 Washing & Timed Drying
To have a good drying the appliance
does not let you set a too low spin speed
for the items to be washed and dried.
1. Press the button Tiempo de secado
to set the drying time value.
After some seconds the display shows
the final time value, that is the total
duration of the washing and drying
cycles (washing + drying + anti-crease +
cooling phases).
If you set only 10 minutes of
drying after washing, the
appliance calculates also the
duration of the anti-crease
and the cooling phases.
2. Press Start/Pausa button to start the
programme.
The indicator comes on. The door is
locked. The display shows regularly a
new time value.
12.3 End of the programme
The appliance stops automatically. The
acoustic signals operate (if they are
active).
For more information see 'At the end of
the drying programme " of the previous
chapter.
1. Turn the selector dial to the position
Off to switch the machine off.
2. Remove the laundry from the
appliance. Make sure that the drum
is empty.
3. Keep the door ajar, to prevent
mildew and odours.
4. Close the water tap.
12.4 Fluff in the fabrics
During the washing and/or drying phase,
some types of fabric, (sponge, sweatshirt)
could release fluff.
www.aeg.com 18