Installation, 1 unpacking – AEG L61270WDBI User Manual

Page 27

Advertising
background image

Problem

Possible solution

The laundry is full of dif-
ferent coloured fluff:

The fabrics washed in the previous cycle released fluff of a dif-
ferent colour.
• Clean the clothes with a fluff remover
• The drying phase helps to eliminate some fluff.
In case of an excessive amount of fluff in the drum, refer to sec-
tion «FLUFF IN THE FABRICS».
• Thoroughly clean the empty drum, the gasket and the door

with a wet rag.

• Perform a rinse cycle.
• Put a wool or piled fabric rag inside the drum.
• Perform a drying cycle of 10 minutes.
• Remove the old wool cloth.

Now you can wash other garments.

After the check, activate the appliance.

The programme continues from the

point of interruption.
If the problem occurs again, contact the

Authorised Service Centre.

If the display shows other alarm codes.

Deactivate and activate the appliance. If

the problem continues, contact the

Service.

16. INSTALLATION

16.1 Unpacking

As you will put down the appliance on the rear side, wait about 6 hours before you use it.
This time is necessary to enable the compressor to work properly.

WARNING!

Remove all the packaging and the transit bolts before installing the

appliance.

Use the gloves. Remove the external film. If
necessary, use a cutter.

ENGLISH

27

Advertising