AEG F99015VI0P - Manual (Page 22)

WHAT TO DO IF…
The start of the appliance does not occur or it stops during operation.
First try to find a solution to the problem (refer to the table). If not, contact the service
centre.
With some malfunctions, the display shows an alarm code:
•
- The appliance does not fill with water
• - The appliance does not drain the water
• - The anti-flood device is on.
WARNING!
Deactivate the appliance before you do the checks.
Malfunction Possible cause Possible solution
The appliance does not fill with
water.
The water tap is blocked or
there is limescale on it.
Clean the water tap.
The water pressure is too low. Contact your local water au-
thority.
The water tap is closed. Open the water tap.
The filter in the water inlet
hose is blocked.
Clean the filter.
The connection of the water
inlet hose is not correct.
Make sure that the connection
is correct.
The water inlet hose is dam-
aged.
Make sure that the water inlet
hose has no damages.
The appliance does not drain
the water.
There is a blockage in the sink
spigot.
Clean the sink spigot.
The connection of the water
drain hose is not correct.
Make sure that the connection
is correct.
The water drain hose is dam-
aged.
Make sure that the water drain
hose has no damages.
The anti-flood device is on. Close the water tap and con-
tact the service centre.
The start of the washing pro-
gramme does not occur.
The appliance door is open. Close the appliance door.
The mains plug is not connec-
ted in the mains socket.
Connect the mains plug.
The fuse in the fuse box is
damaged.
Replace the fuse.
22 What to do if…