AEG L75270FL - Manual (Page 17)

ALTERING AN OPTION OR A
RUNNING PROGRAMME
It is possible to change some options be-
fore the programme carries it out. Before
you make any change, you must press the
button 8 to pause the appliance.
Changing a running programme is possi-
ble only by resetting it.
Turn the programme dial to
and then
to the new programme position.
Press the 8 button again to start the new
programme. The washing water in the tub
will not emptied out.
INTERRUPTING A
PROGRAMME
Press the button 8 to interrupt a pro-
gramme which is running, the corre-
sponding light starts blinking. Press the
button again to restart the programme.
OPENING THE DOOR
When the machine is working and
through the delay time, the door is
locked.
If, for any reason, it is necessary to open
it, firstly press the button 8 to set the ma-
chine to pause
If the light B after a few minutes goes off,
the door can be opened.
If the light B stays on and the door re-
mains locked, this means that the ma-
chine is already heating or that the water
level is too high. In this case the door can
not be opened.
If you cannot open the door but you need
to open it, turn the programme dial to
to switch the machine off. After a few mi-
nutes the door can be opened (pay at-
tention to the water level and tempera-
ture !) .
After closing the door, it is necessary to
set the programme and the options
again. Press button 8 to start the pro-
gramme again.
CANCELLING A PROGRAMME
Turn the selector dial to to cancel a
programme which is running. Now you
can select a new programme.
AT THE END OF THE
PROGRAMME
The machine stops automatically. The pi-
lot light of button 8, the pilot lights A and
B go off. A blinking will appear on the
display.
If you have set a programme or an option
that ends with water in the tub, the light B
remains lit. The door is locked. The water
must be emptied out before opening the
door. During this time the drum continues
to turn at regular intervals until water
drain.
Follow the below instructions to empty
out the water:
• Turn the programme selector dial to
• Set the DRAIN or SPIN programme
• Reduce the spin speed, if needed
• Press the button 8
• When the programme has finished the
display shows a blinking . The pilot
light B goes off. The door can be
opened.
Turn the programme selector dial to
to switch the machine off.
Remove the laundry from the drum and
carefully check that the drum is empty. If
you do not intend to carry out another
wash, close the water tap. Leave the door
open to prevent the formation of mildew
and unpleasant smells.
Stand by : once the programme has fin-
ished after a few minutes the energy sav-
ing system will be enabled. The bright-
ness of the display is reduced. By pressing
any button the appliance will come out of
the energy saving status.
ENGLISH
17