AEG L75270FL - Manual (Page 34)

1
2
• Hinges
To mount the hinges it is necessary to
drill two holes (dia. 35 mm, depth
12.5-14 mm depending on the depth of
door furniture) on the inner side of the
door. The distance between the holes
hobs fixing centres must be 416 mm.
The distance from upper edge of the
door to the centre of the hole depends
on the adjacent furniture's dimensions.
The hinges will be fixed to the door by
means of screws for wood 1 and 2 (Fig.
4) supplied with the appliance.
Fig. 4
B
A
• Mounting the door
Fix the hinges to the appliance by
means of the M5x15 screws . The hing-
es can be adjusted to compensate for
possible uneven thickness of the door.
To align the door perfectly it is necessa-
ry to loosen the screw , adjust the door
and tighten the screw A again (Fig. 5).
Do not remove the screw B (Fig.
5.
Fig. 5
A
B
C
• Counter-magnet
The appliance is prearranged for a
magnetic closure of the door. To ena-
ble a correct operation of this device, it
is necessary to screw the counter-mag-
net A (steel disk + rubber ring) into the
inner side of the door.
Its position must correspond to the
magnet B on the appliance (Fig. 6).
Do not remove the screw C.
Fig. 6
A
B
C
E
D
If the door has to be opened from left to
right, invert the position of the plates E ,
the magnet D and the plate C. Mount the
counter-magnet D and the hinges A as
previously described (Fig. 7 )
CAUTION!
Do not remove the screw B.
34 www.aeg.com