AEG Rear Camera System RV 3.5 - Manual (Page 21)

5 6 9 1
Step 6: Running the camera cable
Now run the camera cable to establish a con-
nection with the cable of the radio transmitter
in the vehicle‘s interior / cavity. Be sure the cables
aren‘t pinched or knotted. Now connect the plug
from the camera cable to the socket of the
radio transmitter .
The plastic ring may optionally be sealed with
conventional sealing compound on both sides to
prevent water from entering.
Step 4: Mounting the camera
Guide the plug for the camera cable through
the plastic ring and into the interior of the
vehicle or the trunk lid. Mount the camera to
the camera brackets evenly spaced from the
sides (see image 4). Mount using the two screws
and the two clamping nuts (see image 5).
Stop turning the clamping nuts when you feel
resistance and the camera is securely connected
to the bracket. Be sure the cable outlet at the back
of the camera always points upward to maintain
the maximum swivel range.
Step 3: Mounting the camera brackets
Mount the two camera brackets and, if appli-
cable, also the number plate frame. Be sure the
distance between the two brackets is no less
than 4 cm (see image 3). The camera may be
mounted above or below the license number.
Image 3 shows installation above the license
number.
Caution! The location of the camera brackets
may not impair the functionality of the license
number light! If it impairs the license number
light mount the camera on the opposite side.
9
9
Image 6
Step 5: Mounting the license number
Now mount the plate (see image 6).
Image 5
Image 4
Image 3
Example: top
mounted camera
Minimum distance 4 cm
Then clip the plastic ring into the borehole
from the outside of the vehicle.
GB 21
8
11
1
1
9
5 6
1
8
1
8
11
97152_R ckfahrkamera_RV3.5_ Manual _07_03_12_Print
Mittwoch, 7. M rz 2012 11:42:17