AEG Rear Camera System RV 3.5 - Manual (Page 25)

The vehicle ignition and the
monitor are switched on and the
car is in reverse but the display
remains dark. The blue LED
doesn‘t light up.
The 12 V monitor cable plug
is not plugged into the vehicle‘s
cigarette lighter or a 12 V outlet.
Plug the 12 V monitor cable
plug into the cigarette lighter
or a 12 V vehicle outlet.
Replace the defective fuse inside
the 12 V monitor cable plug with
a new fuse (see item 4.6). The fuse inside the 12 V monitor
cable plug is burnt out and must
be replaced.
Replace the defective fuse for the
cigarette lighter or the 12 V out-
let inside the vehicle‘s fuse box.
The fuse for the vehicle‘s ciga-
rette lighter or the 12 V outlet is
burnt out and must be replaced.
The ignition is switched on, the
car in reverse, but the monitor
display is blank.
There is no connection between
the camera and the monitor.
The camera cables may not be
correctly connected or have
loosened.
Check if the camera connection
cable is correctly and securely
connected to the reversing light
cable.
The image on the monitor shows
interference. Other wireless appliances (e.g. mo-
bile phone) are interfering with the
signal between monitor and camera. Switch off all other wireless
appliances (e.g. mobile phone).
The wireless connection between
monitor and camera is too weak,
thus interfering with data trans-
mission. Position the transmitter closer to
the monitor or adjust the position
of the monitor.
The monitor image is not dis-
played clearly. The camera lens may be dirty. Carefully clean the camera lens.
Bright light is hitting the camera
lens. The image quality will improve
once you move out of the area of
the interfering light.
Solutions, repair Possible causes Error / malfunction
4.7 Troubleshooting
GB 25
97152_R ckfahrkamera_RV3.5_ Manual _07_03_12_Print
Mittwoch, 7. M rz 2012 11:42:17